General Category > Machines Simulator

Mx opc server 6.10 problem

(1/2) > >>

chengo89:
Hello,

I have a problem to connect the mx opc server 6.10 with machines simulator.
I can communicate between the mx and the io configurator but in the simulator itself there is no response to io even if opc connected

Any ideas?
Thanks,
Chen

EasyPLC_Master:
Hi!

Please inform:
- EasyPLC version
- Machines Simulator version

Have you test to connect EasyPLC with mx opc server 6.10? works ok then? with Machines Simulator works the communication with the IO_Driver_Configurator.exe utility?

chengo89:
Thank you for the quick reply!

EasyPLC Version - 5.9.2.0
Machines Simulator 3 - 1.0.0.0

I did a test with EasyPLC, indeed, it responds.
Also the IO_Driver_Configurator responds well on test mode.

The thing is that when I save the settings in the IO_Driver_Configurator and connects to the machine in the simulator itself
same as this video: https://www.youtube.com/watch?v=d1F4y92g6AQ
even with the "Connected!" label at the left-bottom, there is no response from the IO's

chengo89:
Sorry, I looked again at the sent USB instead of the properties of the files and the versions are-

EasyPLC Version - 5.9.3.B

Machines Simulator 3.3.1.B

chengo89:
???

Navigation

[0] Message Index

[#] Next page

Go to full version